Spare Parts

The Lower Receiver Cap is a factory part for the Extar EP9 and EP45 firearms. This part is connected to the lower and can be replaced by removing the Receiver Extension Bracket.

This is a direct replacement part for the EP45 to replace the firing pin that it came with. Our firing pins and are fluted in order to extend reliability despite obstructions and buildup inside of thhe bolt. THIS PIN IS NOT COMPATIBLE WITH THE EP9.

This is a replacement steel safety which is compatible with EP series pistols. This safety comes with the detent and spring required.

This is a brand new replacement takedown pin for the EP9 and EP45.

This is a brand new, replacement buffer for the EP9 or EP45. This is the factory buffer weight as comes stock with the firearms.

The latest improvement in reliability for the EP9 is the Fluted Firing Pin. Compatible with all EP9 bolts, our new Firing Pins are machined to have flat edges. This leaves more room in the bolt for dirt or debris to build up before a cleaning is needed...

The EP Extractor is a replacement part for either the EP9 or EP45. This extractor comes with our reinforced extractor spring. This is a good spare part to have on hand as a worn out extractor spring can begin to cause some ejection failures.

This is a brand new recoil spring for the Extar EP9 and EP45. (Does not fit the EXP 556) This is the same spring that comes in the firearm from the factory, so there should be no difference in function from stock.